| |
10 of 15 people found this instruction helpful
Parts Used
-
- Infinite Burner Switch - Small Element - 240V
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerGerald from Paris TN
Switch was making a arcing sound when burner was on
REMOVED THE BACK COVER OF THE RANGE. REMOVED THE KNOB FROM THE FRONT OF THE SWITCH. REMOVED 2 SCREWS HOLDING SWITCH TO RANGE. REMOVED WIRES ONE AT A TIME AND CONNECTED TO PROPER POLES ON REPLACEMENT SWITCH AND REINSTALLED NEW SWITCH ON RANGE
|
3 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerJames from Caldwell ID
The indicator light for burners broke and shorted agaist the back panel on range
This caused the burner switch cotacts to arc burning out the switches. It took 30 or 43 minutes to replace the switches and put the range back together. The bake element took 10 min. ti replace. Grandma has her range back and I am a happy grandpa!! Thanks for the help and we saved over $170.00 for the repairs. Jim Johnson
|
2 of 5 people found this instruction helpful
Parts Used
-
- Infinite Burner Switch - Small Element - 240V
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerPERRY from LECANTO FL
New switch was not wired like old one
i first replaced element after old smoked & quit. replaced switch but i noticed when i started to replace the wires one at a time something didn't seem right. after checking the #s on the old one, they didn't match up with the new one.luckily i had the stove diagram from a packet on the back of the stove. i traced each wire according to the diagram and everything worked out fine. i'm just glad i didn't replace each wire to wire.the #'s were on the switch where each wire went which was different than the org. even though they looked the same.
|