1018448-1-S-GE-WD08X10059        -Short Bottom Door Seal
1018448-1-S-GE-WD08X10059        -Short Bottom Door Seal 1018448-2-S-GE-WD08X10059        -Short Bottom Door Seal

Short Bottom Door Seal

PartSelect Number PS1018448

This part is located at the bottom of the door. It prevents water from leaking out of the dishwasher.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Leaking.
  • Compare At

    $51.77
  • You Save

    $8.63
  • Your Price

    $43.14
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 3 reviews What's this?
1-3 of 3
 

25 of 35 people found this instruction helpful

Parts Used

  • Short Bottom Door Seal

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerJohn from Hillsboro OR

Seal around bottom of door leaking heavy water onto floor during use

First you must remove all screws around inside door frame, and remove panel. (I would recommend using something to weight door down after removing panel from door as it will try to continue to close) Flip panel over and remove old seal by simply pulling off, paying close attention to how the seal is fitted and direction it faces. Clean area of any debris,and let the learning curve begin, after several frustrating attempts, I found it easier to install new seal by first installing it backwards by sliding seal along its track and groove, this will allow it to loosen up, then remove it and install the seal by lapping it over the the track and snapping/sliding it into place. The repair itself from the service center would of been $180.00 - $200.00, I did it myself for $39.00. I would recommend anybody with a sense of aptitude and patience to do this repair themselves. After some research I found out that this model and problem is a common repair, which is somewhat ridiculous in my opinion, as the machine itself is only 2 1/2 years old and it came pre-installed in a new home.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 8 people found this instruction helpful

Parts Used

  • Short Bottom Door Seal

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerJohn from Lakeport AL

Door seal was never installed when machine was manufactured

removed two bottom screws on inside door panel and slid seal onto spline, reinstalled screws. Job done

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 10 people found this instruction helpful

Parts Used

  • Short Bottom Door Seal

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerRoger from Demorest GA

Seal was broken

Took screws out of door. Slid bottom seal off and slid new one on.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3