Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS1017375
This is not the entire door, just the framing around the front of it.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Had to discover how to do this the hard way, but the 1st thing you need is a blow-up diagram of the door which you can download from GE's website.Note that all the components in the door save for the 2 handle screws are snap-on.You will need a screwdriver and a putty knife.The door assembly is on a simple pivot hinge which you can lift and pull off the microwave, making it easier to work.On the inside face of the door, locate strip where the outer edge meets the inner door. The plastic strip is about 2" wide and goes all the way around the door. Remove this strip using a putty knife working around it to gently pry it off. Push putty knife into space between plastic strip and outer door panel. This will give access to the 2 handle screws.Unscrew the screws and remove handle.Using putty knife and starting at the top edge of the door near the center, gently pry the outer frame from the latching tabs until the frame comes off.Snap on new frame and working backwards, screw back the handle, then snap back the the plastic strip and rehang your door on the pivot hinge.Remember the parts are plastic so don't over tighten the screws.Also remember to clean the outer glass panel inside and outside before snapping on the outer frame or your fingerprints will be on your microwave.
Help other customers find the most helpful instructions.
Were these instructions helpful?
once we figured out how to get the frame apart, the install of the new door frame was fairly easy..
It was a little difficult getting the damaged door panel removed but with a little work I was able to remove without causing any damage to the back panel. Be careful because the Door glass falls out when you remove the panel.
put the other pieces into the new frame and put the door back on the microwave; getting the glass seated in the new plastic frame was a bit tricky, but the rest was easy; your on-line diagram certainly helped, but some specific directions with the part would have been useful; fast delivery was appreciated
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.