Upper Rack Adjuster Kit - White Wheels, Left and Right Sides W10712395

Hello Steven, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is PartSelect Number PS10065979. The wheel is only sold as part of the Rack Adjuster Kit. Thank you for your inquiry, good luck with this repair!

Hello Kali, thank you for your question. Yes, the PartSelect Number: PS10065979 is the correct adjuster kit that you will need to repair the unit. I hope this helps!

Hi David, Thank you for your question. First you will have to remove your upper dish rack and the old adjust kit. Now, when installing the new kit, count 4 rungs from the back of the basket toward the front. Take your new metal adjuster and thread the shaft through the fourth rung. You may have to tilt it to get it through. When you straighten the part the wheels portion should be on the outside of the rack and the shaft will be on the inside of the rack. Take your positioner clips and use them to secure the adjuster to the rack. You will see two front tabs and two back tabs. The back tabs will also need to be tilted into place so that they are on the inside of the rack. The flat part of the positioner clips should be on the outside of the rack. Then you will push the clips down on to the adjuster to clip them into place. Now you will have to install the adjuster body on to the adjuster. Pull your adjuster all the way down. Tilt the adjusted toward the inside of the rack, you will notice that the adjuster body has a channel that will fit the adjuster. Slide those two pieces into place together. You will have 4 notches on your adjuster body that fit perfectly with your rack. Pull on your metal adjuster to lock it into place. Grab your actuator. You want to make sure that the thumb pad of your actuator is facing toward the inside of the rack and is closer to the front of the rack. Pull the adjuster arm up as far as you can, so that the body is a little bit above the top of the rack. The set the actuator inside of the two slots at the top of the body. You may have to tilt the body toward the inside of the rack to fit the actuator into place. Once you have that part in place, push the whole assembly down and press it back up against the side of the rack into place again. Now you will take the adjuster cover and install it on to the body from the outside of the rack. There is a little tab at the top of the cover, you will have to push that into place in the slot at the top of the adjuster body. That just snaps down into place. Then you install your two T15 Torx screws into the cover to hold it into place. This installation is the same for both sides. I hope that helps. Good luck with your repair.

Hello Andrew, thank you for your question. The rack adjuster kit has been redesigned as the original adjuster was not as stable and was causing issues for customers. The adjuster kit would come with all parts for the right and left side of the upper rack and would be the only parts that would fix the issue you're having. I hope this helps!

Hello Sarah, thank you for your question. Unfortunately, the manufacturer only sells the kit that includes parts for both sides. Good luck with your repair!

Hi Kathi, for model 665.14263k112 you would be looking for part W10712395 and positioner part WPW10195840 if this part is missing. Thank you for your question and good luck with your repair!

Hello Carrie, thank you for writing. This Rack Adjuster Kit part PS10065979 is compatible to your model.

Hello Luciene, Thank you for your inquiry. The part number that is compatible to the model you supplied is W10712394. Hope this helps!

Hello Celine, thank you for writing. This is the correct replacement for your model. It is the only replacement listed for it.

Hello Corey, thank you for inquiring. You will need this Rack Adjuster Kit, part number PS10065979 for your model to get that piece. Good luck with your repair!