Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS10063224
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
remove the old one and put the new one...!!! Easy
Help other customers find the most helpful instructions.
Were these instructions helpful?
I have always been mechanically inclined so when my dryer started making noise I turned it into a family project. I found your website and studied what could be the problem. My 13 year old son and I took the dryer apart and found that it was the front drum bearing. i ordered the parts and my son did most of the work. Only had to take out two screws holding the top on and two holding the front. Vacumed out lint and followed directions on your site to replace parts. up and running in about 30 minutes.
Took the front & top off the dryer. Saw that the slides were missing or broken. Got the parts and put it back together. Works great.
All the stores had either a smaller watt or a larger watt and the book suggested always using the correct watt. I was glad to find it on this sight and it was delivered very quickly.
remove the 2 screws going into the top, remove itremove the 2 screws going to the front panel, set it aside install parts and reverse order. very easy to do
Disassembled and removed drum according to directions on this site. Ordered parts and replaced per instructions - - easy as unscrewing and rescrewing old bearing assembly. Hardest thing was putting the belt on - as I did it fromthe front side and the recommendations are to access from the back kick plate. I did not want to wreck the vent tube so I left the dryer in place and did the entire job from the front.
Screwed the light bulb into the socket (duh)
Took top and front panel off. Pulled top bearing shroud off, replaced and installed the slides on new top bearing. Installed felt gasket on the bottom piece of lower shroud. Installed new lamp and put back together to check out. Dryer working great now. Should have changed the belt but it is not squelling so it is fine.
Losened four hex screws to open up control panel assembly, removed and replaced threee wires from switch with new swithch, re-assembled control panel. Removed old bulb and replaced with new one. All worked well.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.