Models > ZVB36WB3WW

ZVB36WB3WW General Electric Vent Hood - Overview

Get Parts and Repair Help for ZVB36WB3WW

If you know the vent hood repair part you need, you can browse the list of all parts on the ZVB36WB3WW, or you can search by name or part description. You can also find your part by where it is located on the ZVB36WB3WW by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZVB36WB3WW [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Single Roller

Sold individually.


Hood Gear Motor





Sold individually. This filter is for a 36" range hood that requires 2 filters.








SCREW PT BT 6-18 X3/8 N


SCREW 10-24 X 1/4 BTN SO


"COVER 36"" "

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Controller board fried

  • Customer: Anthony from Stevensville MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Wrench set
  • 4 of 5 people found this instruction helpful
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the contr... read more