Models > ZSC2200NBB01

ZSC2200NBB01 General Electric - Overview

Get Parts and Repair Help for ZSC2200NBB01

If you know the repair part you need, you can browse the list of all parts on the ZSC2200NBB01, or you can search by name or part description. You can also find your part by where it is located on the ZSC2200NBB01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.62

FUSE

$17.52

Halogen Bulb - 20W - 12V

Sold Individually.

$67.07

Glass Cooking Tray

This tray rotates in your microwave ensuring more even temperatures.

$26.89

2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

$25.84

Monitor Switch

$24.36

Oven Cavity Temperature Cut-Out

Also known as fuse.

$114.27

Magnetron

This part is used to generate microwave energy/heat.

$14.09

Diode Cable

$10.25

THERMOSTAT

$90.96

Light Lens Cover

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 299 of 393 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

Halogen bulb beneath microwave lighting the stovetop burned out after 9 mo.

  • Customer: Edward from Averill Park NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 14 of 15 people found this instruction helpful
Unscrewed the light cover beneath the microwave with a phillips head screwdriver. The bulb is very tiny and has 2 straight parallel prongs that slide into 2 small holes. Grab bulb from both sides with each hand firmly and slide STRAIGHT out (no twisting or pushing). Don't worry about breaking even though it may take a fair amount of pressure to pull out. ... read more

No power to microwave, no heating.

  • Customer: Michael from Coulterville CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 18 of 32 people found this instruction helpful
Unpluged power cord!! Removed front control panel to expose electronics (need to remove top horizontal vent cover to expose mounting hardware). Unplugged leads to control panel board. Removed magnetron with Tstat (3- phillip heads, need stubby). Installed new parts and control panel, plugged it in tested. Done. read more