Models > ZSC2001FSS02

ZSC2001FSS02 General Electric Microwave - Overview

Get Parts and Repair Help for ZSC2001FSS02

If you know the microwave repair part you need, you can browse the list of all parts on the ZSC2001FSS02, or you can search by name or part description. You can also find your part by where it is located on the ZSC2001FSS02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$16.87

Primary Door Interlock Switch

This interlock switch is located in the door latch.

$55.30

Turntable

Also known as rotating ring assembly.

$7.68

Drawing Lamp

Also known as Light Bulb.

$93.54

TRAY, CERAMIC

$25.84

Monitor Switch

$23.27

Shaft - Turn Table

$83.07

Non-Stick Metal Tray/Pan

$24.36

Oven Cavity Temperature Cut-Out

Also known as fuse.

$90.96

Light Lens Cover

$66.73

Lower Glass Cover

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Everything seemed to work with the controls, but when you pressed start the light would come on and nothing else. The turntable and heating system would not function.

  • Customer: Keith from Bowling Green KY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 15 people found this instruction helpful
I unplugged it, removed the outer shell with torque bits and a screwdriver, drained the main capacitor, and began debugging the circuit with my fluke multimeter, found the bad primary interlock, googled the part number, ordered the part, received it in 2 days, replaced the interlock in about 2 minutes, and put the cover back on. Fixed. Saved me about $200 ... read more

Broken shaft -- turn table would not turn.

  • Customer: James from OKLAHOMA CITY OK
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 10 of 11 people found this instruction helpful
Safety TORX driver removed screw. Ceramic cover removed with ease. Shaft pulled straight up and out. Broken piece not retreivable and left in base of oven. New shaft inserted over "D" stub. Ceramic cover replaced and screw tightened.

When the ceramic cover is removed, this allows the glass cover for the UV heating unit to be removed, cleaned,... read more

No cooking Power

  • Customer: Norbert from Minnetonka MN
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 7 of 7 people found this instruction helpful
Had to remove outer cover (special screws involved). Found the correct part at PartSelect.Com and it arrived 3 days later as promissed.

This oven has diffcult electrical connections at switch to get disconnected. I found it easier with the sw loose and in hand so that the connectors can be released with a small screwdriver.

One has to... read more