Models > ZSA1201RSS01

ZSA1201RSS01 General Electric - Overview

Get Parts and Repair Help for ZSA1201RSS01

If you know the repair part you need, you can browse the list of all parts on the ZSA1201RSS01, or you can search by name or part description. You can also find your part by where it is located on the ZSA1201RSS01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for ZSA1201RSS01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$5.43

Halogen Light Bulb - 120V 20W

Sold individually.

$6.62

FUSE

$40.57

Glass Turntable Tray

$19.00

Grease Filter

$4.91

Halogen Lamp - 50W

Lamp also known as light bulb. Sold individually.

$7.33

Damper Bracket

$5.35

Damper

$26.89

2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

$25.84

Monitor Switch

$83.07

Non-Stick Metal Tray/Pan

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 305 of 399 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

Under the vent light bulbs needed to be replaced

  • Customer: Robert from Naples ME
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 33 of 42 people found this instruction helpful
Turned of f the circuit breaker to the microwave. Unscrewed the cover (1 screw!) popped out the old bulbs and plugged in the new ones, using the bubblewrap as a handle to be sure my skin didn't touch the light bulbs so the oil from my hands didn't damage or shorten the life of the new bulbs. Turned the circuit back on. That's it! read more

This lamp does not have easy access

  • Customer: Walter from Midvale UT
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 19 of 26 people found this instruction helpful
This is the second time that this lamp hase gone out. It is located in a small space in the top of the microwave and you need to remove the top front pannel, then take a screw or two out of a metal shield and bend the shield up to get your hand into the compartment where, if you know how, you can reach in and lift out the reflector shield that the lighbulb ... read more