Models > ZMC1095SF001

ZMC1095SF001 General Electric Microwave - Overview

Get Parts and Repair Help for ZMC1095SF001

If you know the microwave repair part you need, you can browse the list of all parts on the ZMC1095SF001, or you can search by name or part description. You can also find your part by where it is located on the ZMC1095SF001 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZMC1095SF001 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.98

Light Bulb - 40W 130V

Sold individually.

$33.11

Diode

This part allows power to go one way only.

$175.98

Magnetron Assembly

This part is used to generate microwave energy/heat.

$203.54

Exterior Door Panel - Stainless Steel

Also known as Inlay Screen Assembly.

$59.14

Capacitor

The capacitor is an electric circuit element that is used to store charge temporarily.

$7.89

FUSE 250V 15A

$191.34

Inner Door Panel with Glass - Black

Also known as liner and choke assembly.

$115.54

GAS SENSOR

$8.54

DOOR-KEY

$3.62

SPRING KEY

Common Symptoms of the ZMC1095SF001 [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bulb had broken off in base that was still screwed into socket

  • Customer: william from san antonio TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 38 of 41 people found this instruction helpful
At first I tried to use pliers to unscrew the base,very uncomfortable working position,upside down and backwards(the microwave is installed over the range top)very limited space for your body and arms to manuver and you really cant see the base,all of this took place after the breaker was turned off ofcourse,finally figured out that you can drop the entire b... read more

Not working as far as heating or cooking

  • Customer: Theodore from Medical Lake WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 52 of 130 people found this instruction helpful
Replaced High Voltage Diode. Very carfully due to the extream danger of a electrical shock. read more

Changing the bulb that illuminates the cooktop

  • Customer: LUCY from BALLWIN MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 14 of 17 people found this instruction helpful
Loosen screw holding glass cover plate in place over bulb. Glass cover plate will swing down. Unscrew bad bulb, replace with good bulb, reset glass cover and tighten screw. read more