Models > ZMC1095BF02

ZMC1095BF02 General Electric Microwave - Overview

Get Parts and Repair Help for ZMC1095BF02

If you know the microwave repair part you need, you can browse the list of all parts on the ZMC1095BF02, or you can search by name or part description. You can also find your part by where it is located on the ZMC1095BF02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZMC1095BF02 [Viewing 1 of 1]

$5.84

Light Bulb - 40W 130V

Sold individually.

$33.11

Diode

This part allows power to go one way only.

$175.98

Magnetron Assembly

This part is used to generate microwave energy/heat.

$3.62

SPACER-RACK

$59.14

Capacitor

The capacitor is an electric circuit element that is used to store charge temporarily.

$157.22

CER TRAY ASM

$2.83

PCB SUPPORT

$12.16

SWITCH

$12.16

SWITCH-MICRO

$10.04

THERMOSTAT

Common Symptoms of the ZMC1095BF02 [Viewing 1 of 57]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bulb had broken off in base that was still screwed into socket

  • Customer: william from san antonio TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 46 of 49 people found this instruction helpful
At first I tried to use pliers to unscrew the base,very uncomfortable working position,upside down and backwards(the microwave is installed over the range top)very limited space for your body and arms to manuver and you really cant see the base,all of this took place after the breaker was turned off ofcourse,finally figured out that you can drop the entire b... read more

Not working as far as heating or cooking

  • Customer: Theodore from Medical Lake WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 70 of 180 people found this instruction helpful
Replaced High Voltage Diode. Very carfully due to the extream danger of a electrical shock. read more

microwave would not heat up

  • Customer: Thomas from Gilbert AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 20 people found this instruction helpful
I removed the microwave unit (built-in) from the housing above the built-in oven with just two screws and unplugging it. I then removed the screws from the top and sides of the microwave access panels to allow access to the magnetron. I then removed the electrical connections from the magnetron, which is very simple and then the screws which held the magnet... read more