Models > ZMC1090BV02

ZMC1090BV02 General Electric Microwave - Overview

Get Parts and Repair Help for ZMC1090BV02

If you know the microwave repair part you need, you can browse the list of all parts on the ZMC1090BV02, or you can search by name or part description. You can also find your part by where it is located on the ZMC1090BV02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZMC1090BV02 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.98

Light Bulb - 40W 130V

Sold individually.

$19.43

Secondary Door Switch

$63.21

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$191.34

Inner Door Panel with Glass - Black

Also known as liner and choke assembly.

$115.54

GAS SENSOR

$8.54

DOOR-KEY

$5.55

Ceramic Fuse - 15 Amp

$3.62

SPRING KEY

$3.21

PIN-DOOR KEY

$3.62

SPACER-RACK

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 62 of 73 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more

bulb had broken off in base that was still screwed into socket

  • Customer: william from san antonio TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 38 of 41 people found this instruction helpful
At first I tried to use pliers to unscrew the base,very uncomfortable working position,upside down and backwards(the microwave is installed over the range top)very limited space for your body and arms to manuver and you really cant see the base,all of this took place after the breaker was turned off ofcourse,finally figured out that you can drop the entire b... read more

Turntable won't move, no heat -but light and fan ok.

  • Customer: Sean from San Jose CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 16 of 18 people found this instruction helpful
Remove the 2 Torx-15 screws at left of control panel. Work the control panel out by pulling slightly to the left first - it is engaged to the slotted holes to the right.

Remove the door's upper switch by lifting the tab and pulling out the switch carefully. To install the new switch, you may have to remove 2 philips screws holding the plastic asse... read more