ZISW480DMB General Electric Refrigerator - Instructions

Had a water leak on that valve for probably the last 7 or 8 years. Only noticed it when I had a huge water issue with a leaky faucet. Repaired that, went to repair the Sheetrock behind refrigerator and saw water in the tray under frige. Wiggle hose and realized that the reason the water on the front door would only trickle out was because the leak on that valve was also affecting the pressure on the front door. Unreal!! The website and video made it incredibly simple to replace, u guys rock, for real!!!

I followed the video instructions. They were clear and consise. I removed the trim ring and controls. Them removed the housing and flapper. I did notice a small burr in the plastic chute and foam insulation. I trimmed this off with a utility in hopes this burr caused the flapper to warp. This is the 2nd time the flapper has been replaced in 1.5 yrs. The repair was really easy thanks to the video.

Very easy to replace these parts. Thankas to part select for telling me how to do it. You are very helpful.

The video instructions were outstanding in showing how this repair was to be completed. Follow these instructions and Job was very easy. Replaced ice shute flapper and arm, soloinoid and Micro switch for water flow control. Reassemble by reversing procedure. Follow video instructions on how to replace water control valve in back of fridge. Test water flow at bottom front of fridge and defrost flow tube in door if necessary. I used tupperware container with hot water on top of ice shute shelf in fridge door. A couple of times changing and water was flowing. Great site and detailed video instructions for an effective and cost saving self repair. I saved several service trips and service calls and labor costs of a service tect. Parts costs were also a lot cheaper than service tech would have charged. Thanks PartSelect.

remove 3 bucket screws. 1 bracket screw slide bucket back insert drive reverseb steps

Watch to step by step video instructions on your site. Great service! Part arrived the following day after order!

It was exactly as shown in your instruction video

Exactly as the instruction video said. I could have done it without the instructions but I would not have cut a piece off the two water lines and possibly had problems down the road. Also, I may not have figured out the easy way to remove the two lines from the valve body. I believe this is my 3rd time using your process and it's absolutely the best. I won't go anyplace else. Next project is probably replacing the ice maker.

We watched the video on your web site and was very helpful. We ordered the part from your site was here very quickly. It took us about Fifteen minutes to replace. Saved us alot of money. Thanks so much for all your help.

it was easy the only thing was i had to cut old harness to remove 2 wires that went to coil that had to go back in the new harness other then that a peice of cake.

Watched à video provided at your website. Removed te cover then removed 4 screws holding the control panel' snapped out the old flap and inserted the new one.

My son replaced both temperature sensors and the fridge works great now!!! Like brand new again!!!!

Removed frame, unscrewed the electrical panel, and popped the flapper off. Installed new flapper. Replaced the electrical panel and re-installed the frame.

Removed the ice maker control panel and accessed the flapper door, easy switch out for new door and seal. The 2 year old warped seal didn't close and so ice crystals formed in the freezer - new unwarped part and Ta-Da no more problems :)

1.Unplug and turn off water supply to refrigerator. 2.Remove several screws from back panel and remove panel 3. Remove water supply line from valve. 4. Remove screw holding valve on using 1/4" nut driver or socket. 5.Remove the 2 electrical plugs and 2 water lines from valve. 6.reinstall in reverse order. This is a 5 minute job at best. Good Luck! I had my fridge in storage for several years and when it froze it cracked the storage tank PS783769 I replaced it first and found valve was leaking after tank was replaced.