Models > ZISS42GDXASS

ZISS42GDXASS General Electric - Overview

Get Parts and Repair Help for ZISS42GDXASS

If you know the repair part you need, you can browse the list of all parts on the ZISS42GDXASS, or you can search by name or part description. You can also find your part by where it is located on the ZISS42GDXASS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for ZISS42GDXASS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$61.43

Ice and Water Filter

Sold individually. NOTE: As per the manufacture this is an updated water filter. If you have never installed the updated filter or your old filter was made by Culligan, you may ne...

$31.30

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$2.14

Dispenser Light Bulb - 12V

Sold individually.

$43.67

Evaporator Fan Motor

Note: Thermistor is NOT included. If you need the motor with the thermistor, see related parts. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

$3.32

Dispenser Door Recess Crank

$1.53

Compression Ring

$20.09

Ice Funnel

This paddle, when your glass is pushed against it, activates the dispenser to release the ice through the funnel.

$1.78

Lid Bumper

$43.41

DC Condenser Fan Motor

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

$10.68

Dispenser Housing Shield

This part helps to contain parts for the ice and water dispenser. The overlay and dispenser board is attached on the front of the housing shield.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace water filter

  • Customer: Alfred from Novato CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 167 of 250 people found this instruction helpful
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple. read more

Evaporator motor sounded like wind in the trees howling

  • Customer: DOUG from MARYSVILLE OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 62 of 66 people found this instruction helpful
I had to remove all of the shelves.....part of the ice maker.....the rear cover over the freezer coils.....There were two wires that came from the back of the freezer that were also incorporated with the fan motor plug from the factory....This caused me to cut all of the wires from the new motor and soider them to the existing plug and shrink wrap the connec... read more

Warm freezer and no ice

  • Customer: Paul from Suwanee GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 57 of 69 people found this instruction helpful
This story starts with a GE side-by-side refrigerator that has always had wide temperature swings and a temperamental water dispenser. The ice maker was not making ice, and the built in digital thermometer showed it was running warm. I suspected that the heat exchanger was full of dust and so looked there. What I found was that the condenser tank was hot ... read more