Models > ZGU36KSK2SS

ZGU36KSK2SS General Electric Range - Overview

Get Parts and Repair Help for ZGU36KSK2SS

If you know the range repair part you need, you can browse the list of all parts on the ZGU36KSK2SS, or you can search by name or part description. You can also find your part by where it is located on the ZGU36KSK2SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZGU36KSK2SS [Viewing 2 of 2]


Grate Foot

Sold individually. The grate foot is located under the grate to protect the stove top.



This screw is sold individually.





Single Screw Only

Sold Individually.


Gas Pressure Regulator

This comes set from the manufacturer for Natural Gas. It also includes the conversion to Liquid Propane. This valve automatically cuts off the flow of gas at a certain pressure.


Burner Gasket


Control Knob Seal

Sold individually. This seal prevents any leaks from getting under the cooktop or into the switch area.


SCREW 6-32 MCH FHT15 984


Burner Head - C

This part distributes flame evenly to your cookware. This part does NOT include the burner cap.


Burner Gasket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Grate Foot had worn out

  • Customer: Kathryn from Star City AR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 9 of 11 people found this instruction helpful
A rubber grate foot on my range top had worn out. I pulled the worn foot out and installed the new grate foot with no tools or accessories. Good as new! Now I don't have to worry about the grate scraping my range top and scratching the paint. I also ordered extras so I won't have to wait if another wears out. read more

feet keep falling off

  • Customer: Richard from Stratham NH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
Inserted the grate foot into the spot provided; after consulting the parts manuel to insure I was using the proper procedure.

I do use silicone to help hold the foot but it still won't hold read more

burner would not light because spark was skiping to ground elsewhere

  • Customer: David A from Spring TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 2 of 3 people found this instruction helpful
First I removed two screws holding head in place and carefully lifted assembly up using flat screwdriver. I separated old igniter from feed wire with gentle pull. I reversed assembly after cleaning old gasket residue. torque screws back in place after cleaning with small ss wire brsh in dremel tool. Tighten in steps to firm light touch. I used new g... read more