Models > ZEU769TC1WW

ZEU769TC1WW General Electric Range - Overview

Get Parts and Repair Help for ZEU769TC1WW

If you know the range repair part you need, you can browse the list of all parts on the ZEU769TC1WW, or you can search by name or part description. You can also find your part by where it is located on the ZEU769TC1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEU769TC1WW [Viewing 1 of 1]

$1.70

Screw

This screw is sold individually.

$110.80

Dual Haliant Element with Limiter - 9" - 2500W

$55.52

Dual Infinite Control Switch - 3000W

$80.95

Haliant Burner with Limiter - 6" - 1500W

$2.36

Single Screw Only

Sold Individually.

$16.02

Foam Rubber Tape

$3.62

Secure Down Bracket

$52.13

Selector Switch

$2.79

SCREW-10AB

$12.38

INDICATOR LIGHT

Common Symptoms of the ZEU769TC1WW [Viewing 1 of 358]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Large burner on dual element burned out

  • Customer: Scot from Oakland FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench(Adjustable)
  • 46 of 56 people found this instruction helpful
This was really easy, and pretty with no problems or issues It took me longer to write this than to do the actual installation. I used a digital camera to help me remember where things were, but a pen/paper works fine. Here's what I did:

1. Turn off the breaker for the cooktop.

2. Remove (2) 1/4" hex screws directly under cooktop. You m... read more

COIL BURNED OUT

  • Customer: Frank from St Augustine FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 32 of 53 people found this instruction helpful
OPEN LID,UN SCREW COIL,POP IN NEW COIL SNAP HOLDERS IN PLACE,THEN COOK A STEAK read more

Cooktop Burner was always on High no matter what the setting on the Control

  • Customer: Raymond from Salt Point NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 16 of 19 people found this instruction helpful
1) Turn Power off at Circuit Breaker
2) Lift Cooktop out of counter top.
3) Remove all dials from controls by pulling straight up.
4) Remover glass plate which covers burners by removing
screws along outer edge.
5) Remove the two top screws from the control to be
replaced (this holds the infinite control to bracket)
... read more