Models > ZEU669A1WW

ZEU669A1WW General Electric Range - Overview

Get Parts and Repair Help for ZEU669A1WW

If you know the range repair part you need, you can browse the list of all parts on the ZEU669A1WW, or you can search by name or part description. You can also find your part by where it is located on the ZEU669A1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEU669A1WW [Viewing 1 of 1]



This screw is sold individually.


Single Screw Only

Sold Individually.


Dual Infinite Control Switch - 3000W


Secure Down Bracket


Selector Switch




Switch Seal

This part goes between the infinite switch (under the cooktop) and the knob.




Haliant Element - 1200W



Common Symptoms of the ZEU669A1WW [Viewing 1 of 66]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Cooktop Burner was always on High no matter what the setting on the Control

  • Customer: Raymond from Salt Point NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 19 of 22 people found this instruction helpful
1) Turn Power off at Circuit Breaker
2) Lift Cooktop out of counter top.
3) Remove all dials from controls by pulling straight up.
4) Remover glass plate which covers burners by removing
screws along outer edge.
5) Remove the two top screws from the control to be
replaced (this holds the infinite control to bracket)
... read more

cook top burner stayed on high

  • Customer: Roy from Yardley PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
using the info on this site i guessed it was the switch. It was. this is a Radiant Heat in counter drop on cook top. i was nervous about getting it out of the counter but that was eassy, just sits on top. the One issue was diconnecting the BX electric cable from the elecric box. mine did not have threads and a nut. but a push in fitting with small tabs.. i f... read more

The shaft on the selector switch broke.

  • Customer: David from Porter Ranch CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 6 of 8 people found this instruction helpful
You have to replace the switch if the shaft breaks (I think we hit it with a pot). This is a flat glass cook top. Turn off the power at the breaker box. I took the drawers out below the cook top and loosened the bracket holding the electrical conduit. That allowed me to push up the cook top from below. There is some adhesive but nothing hold it except its ow... read more