Models > ZEU36KSK1SS

ZEU36KSK1SS General Electric Range - Overview

Get Parts and Repair Help for ZEU36KSK1SS

If you know the range repair part you need, you can browse the list of all parts on the ZEU36KSK1SS, or you can search by name or part description. You can also find your part by where it is located on the ZEU36KSK1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEU36KSK1SS [Viewing 1 of 1]

$27.12

Infinite Control Switch

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$49.55

Dual Burner Control Switch

This switch controls the dual burner.

$16.02

Foam Rubber Tape

$3.62

Secure Down Bracket

$16.66

Switch Seal

This part goes between the infinite switch (under the cooktop) and the knob.

$3.00

WASHER

$172.55

Haliant Element - 12"

$27.62

Tape

This roll contains 108 inches of tape.

Common Symptoms of the ZEU36KSK1SS [Viewing 1 of 145]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Switch failed

  • Customer: John from Fresno CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 13 of 17 people found this instruction helpful
I turned off the circuit breaker and tested the cook top. I pulled the cook top out and laid a piece of plywood over the opening to work on the cook top and not scratch the granite counter top. The mistake I made was to turn the cook top upside down and separate the top from the housing. The dampening springs came off the burners and I could have damaged ... read more

Electric range burner not working due to control switch

  • Customer: Rodney from Erath LA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 11 of 16 people found this instruction helpful
Turned off power to counter top range and pulled-up from counter. Set range on counter and removed 16 screws from around the housing allowing me to pull-up and remove range top. Used socket to remove 4 screws holding control switch bracket in place and 2 screws holding bad switch in place. Disconnect wires from bad switch and reconnected to new switch. Place... read more

RF Dual Burner out. Smoke in the area of controls

  • Customer: Al from Ocala FL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 7 of 8 people found this instruction helpful
Shut off circuit breaker. Removed cooktop from island counter. Removed all knobs. Removed all screws after finding layout diagrams of unit on your web site. Lifted glass top from metal cabinet. Ordered control after trouble shooting the problem. (Master Electrician). Obviously burned out from water in control. Ordered control on line and installed it when it... read more