Models > ZET958BF1BB

ZET958BF1BB General Electric Range - Overview

Get Parts and Repair Help for ZET958BF1BB

If you know the range repair part you need, you can browse the list of all parts on the ZET958BF1BB, or you can search by name or part description. You can also find your part by where it is located on the ZET958BF1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$13.89

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$53.82

Broil Element

This broil element is found on the roof of the oven.

$16.87

Broiler Pan - Large

Includes the pan and grate.

$8.98

Halogen Lamp - 35 Watt

$37.80

WINDOW PACK ASM

$2.79

Screw

Sold Individually.

$132.84

Probe Sensor

This probe is used to check the internal temperature of the meat to ensure proper temperature is reached. Also known as a Meat Probe.

$45.29

Convection Element

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 20 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

Broil (top) element replacement for oven

  • Customer: robert from pine valley CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 16 of 17 people found this instruction helpful
After turning the breaker off, using a 1/4 inch nut driver I removed all the clamp screws (5) holding the heating element in place. I then unplugged the element wire spades from the rear of oven and removed the old element. Installing the new one was simply going in reverse order. After plugging the new one in, I did however, use plyers to squeeze the connec... read more

Convection oven fan and door light not working

  • Customer: Michael from Albuquerque NM
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 10 of 12 people found this instruction helpful
The first step was to determine whether the problem was with the fan itself or the switch. I did this by opening the back cover and using a Volt meter to verify that the fan was not getting power. (I could have skipped this step.)

Next, I unplugged the range, closed up the back cover and lifted the range hood by removing two hex head screws that a... read more