Models > ZET938SF2SS

ZET938SF2SS General Electric Range - Overview

Get Parts and Repair Help for ZET938SF2SS

If you know the range repair part you need, you can browse the list of all parts on the ZET938SF2SS, or you can search by name or part description. You can also find your part by where it is located on the ZET938SF2SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZET938SF2SS [Viewing 5 of 5]

$13.89

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$8.98

Halogen Lamp - 35 Watt

$16.87

Broiler Pan - Large

Includes the pan and grate.

$53.82

Broil Element

This broil element is found on the roof of the oven.

$23.05

Door Light Switch

$4.21

SCREW

$70.05

PACK WINDOW ASM

$132.84

Probe Sensor

This probe is used to check the internal temperature of the meat to ensure proper temperature is reached. Also known as a Meat Probe.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broil (top) element replacement for oven

  • Customer: robert from pine valley CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 15 of 15 people found this instruction helpful
After turning the breaker off, using a 1/4 inch nut driver I removed all the clamp screws (5) holding the heating element in place. I then unplugged the element wire spades from the rear of oven and removed the old element. Installing the new one was simply going in reverse order. After plugging the new one in, I did however, use plyers to squeeze the connec... read more

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 15 of 18 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

My light switch housing broke, making the oven light stay on all the time.

  • Customer: Frederick from Lovettsville VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 16 of 22 people found this instruction helpful
Most important: Unplug or turn off the breaker before beginning! (I briefly saw sparks as I removed the old switch.) Look at the replacement switch. The springs on the sides hold the switch in, which means you have to press in these springs to get the old switch out. I slipped a small screwdriver in on the side while I pulled with a small pair of pliers.... read more