Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZET938SF1SS

ZET938SF1SS General Electric Wall Oven - Overview

Get Parts and Repair Help for ZET938SF1SS

If you know the wall oven repair part you need, you can browse the list of all parts on the ZET938SF1SS, or you can search by name or part description. You can also find your part by where it is located on the ZET938SF1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.21

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$43.21

WINDOW PACK ASM

$18.66

Broiler Pan - Large

Includes the pan and grate.

$2.06

Screw

This screw is sold individually.

$2.91

Screw

Sold Individually.

$47.90

Convection Element

$9.75

Halogen Lamp - 35 Watt

$3.20

SCREW

$4.58

SCREW

$3.33

Screw

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch, CO
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 34 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

Broil (top) element replacement for oven

  • Customer: robert from pine valley, CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 18 people found this instruction helpful
After turning the breaker off, using a 1/4 inch nut driver I removed all the clamp screws (5) holding the heating element in place. I then unplugged the element wire spades from the rear of oven and removed the old element. Installing the new one was simply going in reverse order. After plugging the new one in, I did however, use plyers to squeeze the connec... read more

Aluminum Foil Bonded With Bottom

  • Customer: Linda from Oro Valley, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 15 of 16 people found this instruction helpful
It was much easier than trying to remove the bonded aluminum foil from the false bottom/drip pan. Simply lift and remove oven front door, (see your manual), slide out false bottom and slide in new. For me it did take longer than 15 minutes, but that's because I was doing a thorough oven cleaning. The part was in the $50 range and well worth it. Why didn't an... read more