Models > ZEM200GY01

ZEM200GY01 General Electric Microwave - Overview

Get Parts and Repair Help for ZEM200GY01

If you know the microwave repair part you need, you can browse the list of all parts on the ZEM200GY01, or you can search by name or part description. You can also find your part by where it is located on the ZEM200GY01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEM200GY01 [Viewing 1 of 1]

$19.43

Secondary Door Switch

$5.55

Ceramic Fuse - 15 Amp

$175.98

Magnetron Assembly

This part is used to generate microwave energy/heat.

$110.00

Rectangle Glass Tray

$63.21

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$59.14

Capacitor

The capacitor is an electric circuit element that is used to store charge temporarily.

$2.79

Spring - Button

$12.16

LAMP-INCANDESCENT

$10.46

THERMOSTAT

$93.46

SENSOR HUMIDITY

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 93 of 113 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more

Turntable won't move, no heat -but light and fan ok.

  • Customer: Sean from San Jose CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 19 of 22 people found this instruction helpful
Remove the 2 Torx-15 screws at left of control panel. Work the control panel out by pulling slightly to the left first - it is engaged to the slotted holes to the right.

Remove the door's upper switch by lifting the tab and pulling out the switch carefully. To install the new switch, you may have to remove 2 philips screws holding the plastic asse... read more

microwave would not heat up

  • Customer: Thomas from Gilbert AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 20 people found this instruction helpful
I removed the microwave unit (built-in) from the housing above the built-in oven with just two screws and unplugging it. I then removed the screws from the top and sides of the microwave access panels to allow access to the magnetron. I then removed the electrical connections from the magnetron, which is very simple and then the screws which held the magnet... read more