Models > ZEK938SF6SS

ZEK938SF6SS General Electric Range - Overview

Get Parts and Repair Help for ZEK938SF6SS

If you know the range repair part you need, you can browse the list of all parts on the ZEK938SF6SS, or you can search by name or part description. You can also find your part by where it is located on the ZEK938SF6SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$1.93

Screw

This screw is sold individually.

$2.79

Single Screw Only

Sold Individually.

$17.95

Broiler Pan - Large

Includes the pan and grate.

$3.00

Screw

Sold Individually.

$33.52

Meat Probe Thermistor

$9.41

Halogen Lamp - 35 Watt

$4.48

SCREW

$24.36

Door Light Switch

$3.00

SCREW-10AB

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 39 of 52 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Replace failed fan in control box

  • Customer: David from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Socket set
  • 15 of 16 people found this instruction helpful
After turning off the breaker to cut power to the oven, I opened the oven door and, using the PartSelect exploded diagram as a guide, I removed 3 screws from the underside of the control panel - I was then able to slide the panel up and out to remove it. Leaving all of the control wires (especially the ribbon) connected to control panel, I saw the fan assemb... read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 16 of 19 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more