Models > ZEK937SD1SS

ZEK937SD1SS General Electric Oven - Overview

Get Parts and Repair Help for ZEK937SD1SS

If you know the oven repair part you need, you can browse the list of all parts on the ZEK937SD1SS, or you can search by name or part description. You can also find your part by where it is located on the ZEK937SD1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEK937SD1SS [Viewing 5 of 5]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$17.95

Broiler Pan - Large

Includes the pan and grate.

$4.48

SCREW

$1.93

Screw

This screw is sold individually.

$2.79

Screw

Sold Individually.

$3.00

Screw

Sold Individually.

$24.36

Door Light Switch

$9.41

Halogen Lamp - 35 Watt

$138.82

Temperature Probe

This probe is used to check the internal temperature of the meat to ensure proper temperature is reached. Also known as a Meat Probe.

$9.82

HUB BLADE ASM

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 47 of 62 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Replace failed fan in control box

  • Customer: David from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Socket set
  • 19 of 20 people found this instruction helpful
After turning off the breaker to cut power to the oven, I opened the oven door and, using the PartSelect exploded diagram as a guide, I removed 3 screws from the underside of the control panel - I was then able to slide the panel up and out to remove it. Leaving all of the control wires (especially the ribbon) connected to control panel, I saw the fan assemb... read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 17 of 22 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more