Models > ZEK757WP1WG

ZEK757WP1WG General Electric Range - Overview

Get Parts and Repair Help for ZEK757WP1WG

If you know the range repair part you need, you can browse the list of all parts on the ZEK757WP1WG, or you can search by name or part description. You can also find your part by where it is located on the ZEK757WP1WG by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ZEK757WP1WG parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEK757WP1WG [Viewing 3 of 3]

$36.10

Bake Element

This bake element is found on the bottom of the oven.

$4.27

Single Heating Element Support Clip

This metallic clip is used to help support the broil element. Sold individually.

$1.70

Screw

This screw is sold individually.

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$39.45

Broil Element - 240V

This oven broil element has push-on terminals.

$2.36

SCREW

Sold Individually.

$1.27

SCREW

$4.41

Light Cover

$2.36

Single Screw Only

Sold Individually.

$16.87

Broiler Pan - Large

Includes the pan and grate.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 152 of 176 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

bake element shorted out, sparking like a sparkler

  • Customer: Carl from Wynnewood PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 49 of 52 people found this instruction helpful
first, made sure circuit breaker was off
second, used nut driver to remove 2 screws on old element, pulled it from the back of the oven
third, removed 2 wires from old element (spade connectors)
fourth, connected new element and pushed back into oven.
fifth, reinstalled 2 screws securing new element

this was all done by my 15 y... read more

Convection Fan motor was (way) noisy

  • Customer: daniel from sayville NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 34 of 34 people found this instruction helpful
Fan motor has to be removed from the rear. Since this is a (double) wall oven, the hardest part was sliding the oven out of the wall.

First, doors are removed, eight screws that hold the oven in place (along the side of the doorways) are removed. The rear panel inside the oven must be removed to expose the fan. Four screws hold that in place. read more