Models > ZEK757WA1WW

ZEK757WA1WW General Electric Range - Overview

Get Parts and Repair Help for ZEK757WA1WW

If you know the range repair part you need, you can browse the list of all parts on the ZEK757WA1WW, or you can search by name or part description. You can also find your part by where it is located on the ZEK757WA1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ZEK757WA1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEK757WA1WW [Viewing 5 of 5]

$4.27

Single Heating Element Support Clip

This metallic clip is used to help support the broil element. Sold individually.

$1.70

Screw

This screw is sold individually.

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$39.45

Broil Element - 240V

This oven broil element has push-on terminals.

$2.36

SCREW

Sold Individually.

$1.27

SCREW

$4.41

Light Cover

$2.36

Single Screw Only

Sold Individually.

$16.87

Broiler Pan - Large

Includes the pan and grate.

$2.79

Screw

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 153 of 178 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

The broiler element caught fire and burned out while I was broiling a steak.

  • Customer: Dianne from Rockville MD
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 32 of 38 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches, but I had not turned off the power.
So, I shorted out one of the wires. Then I turned off the power but was afraid to go any farther.
An appliance repairman was at my house that day fixing my dryer seal. He was able to pull the wires through... read more

Oven would not heat to the correct temperature

  • Customer: Michael from Lawrenceville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 32 of 51 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires read more