- Customer: James from Austin TX
- Difficulty: Easy
- Time to Complete: 1- 2 hours
- Tools Required: Nutdriver, Screw drivers
- 148 of 171 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t...
- Customer: Carl from Wynnewood PA
- Difficulty: Really easy
- Time to Complete: Less than 15 mins
- Tools Required: Nutdriver
- 48 of 51 people found this instruction helpful
first, made sure circuit breaker was off
second, used nut driver to remove 2 screws on old element, pulled it from the back of the oven
third, removed 2 wires from old element (spade connectors)
fourth, connected new element and pushed back into oven.
fifth, reinstalled 2 screws securing new element
this was all done by my 15 y...
- Customer: daniel from sayville NY
- Difficulty: A Bit Difficult
- Time to Complete: 30 - 60 mins
- Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
- 33 of 33 people found this instruction helpful
Fan motor has to be removed from the rear. Since this is a (double) wall oven, the hardest part was sliding the oven out of the wall.
First, doors are removed, eight screws that hold the oven in place (along the side of the doorways) are removed. The rear panel inside the oven must be removed to expose the fan. Four screws hold that in place. read more