Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZEK737BA1BB

ZEK737BA1BB General Electric Wall Oven - Overview

Get Parts and Repair Help for ZEK737BA1BB

If you know the wall oven repair part you need, you can browse the list of all parts on the ZEK737BA1BB, or you can search by name or part description. You can also find your part by where it is located on the ZEK737BA1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for ZEK737BA1BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZEK737BA1BB

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.05

Single Heating Element Support Clip

This metallic clip is used to help support the broil element. Sold individually.

$45.50

Broil Element - 240V

This oven broil element has push-on terminals.

$102.68

Oven Sensor

This sensor detects the temperature within the oven cavity.

$2.91

SCREW

Sold Individually.

$7.05

Light Cover

$19.31

Broiler Pan - Large

Includes the pan and grate.

$2.91

Screw

Sold Individually.

$2.02

Screw

This screw is sold individually.

$2.09

BAIL

$3.33

Screw

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin, TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 186 of 212 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

The broiler element caught fire and burned out while I was broiling a steak.

  • Customer: Dianne from Rockville, MD
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 44 of 50 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches, but I had not turned off the power.
So, I shorted out one of the wires. Then I turned off the power but was afraid to go any farther.
An appliance repairman was at my house that day fixing my dryer seal. He was able to pull the wires through... read more

Top broiler element went out

  • Customer: Kim from Garland, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 27 of 28 people found this instruction helpful
FIRST MAKE SURE THE OVEN IS OFF!!!! I chose to shut it off at the breaker panel. Remove the two screws that attaches the broiler element to the oven. Gently pull it out. Unplug the two cable wires that are attached. Replace it and install the same way. read more