Models
>
ZDIC150WSSA
ZDIC150WSSA General Electric Ice Maker - Overview
Sections of the ZDIC150WSSA
[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
1/4 Tubing Nut
PartSelect #: PS304401
Manufacturer #: WR57X57
This is a quarter tubing nut and is sold individually. The tubing nut works in conjunction with your refrigerator/freezer and is made entirely of plastic. The function of this part is to connect the l...
$8.06
In Stock
Water Line - 1/4"
PartSelect #: PS292409
Manufacturer #: WR17X1948
This water line 1/4, also known as a ice maker fill tube, is used in freezers and refrigerators. The tube directs the water into the ice maker cup during the cycle in which it fills the cup. The water...
$24.87
In Stock
Ice Cutting Grid
PartSelect #: PS1155288
Manufacturer #: WR29X10073
This ice cutting grid is located behind the ice maker door. The cutting grid consists of thin, heated metal wires that slice the slabs of ice when they slide off the evaporator plate, creating the cub...
$573.13
Special Order
HINGE STOP TOP RH/BTM Left Hand
PartSelect #: PS284826
Manufacturer #: WR02X10375
No Longer Available
Questions And Answers for ZDIC150WSSA
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the ZDIC150WSSA
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
water line cracked
I loosened the compression nut on the valve with my fingers and pulled the water line free from the valve. On the other end, I just pulled it from the hose clamp. Installation in reverse. Force the water line into the fitting on top, Slide the old nut over the line on the bottom. Screw the nut onto the valve. Reach inside the freeze
... Read more
r and turn on the ice maker. Done. Before replacing the cardboard grill, you should vacuum the coils on the bottom, front and back. If practical, push it outside and blow it out with an air compressor or a leaf blower.
Read less
Parts Used:
-
RUSSELL from BLACK HAWK, SD
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
ice maker pump and water line leaking
I replaced both the punp and water line. the website depicting the repair parts was the best i ever worked with. The parts were high quality delivered on time and easy to install. Total job cost $30 as opposed the cost of of a service man or a new refrig.
Parts Used:
-
Edward from Jenks, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers
2 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Failure to make ice
Unit was failing to make ice as a result of cutting grid fail (broken cutting wire disrupted circuit so no heating) and corresponding ice build up on cooling plate. Defective cutting grid swapped out - replacement part had superior design to OEM and was made of comparable to superior materials. Very satisfied.
Parts Used:
-
James from Baltimore, MD
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!