Models > ZCG3300VWW-02

ZCG3300VWW-02 General Electric Trash Compactor - Overview

Get Parts and Repair Help for ZCG3300VWW-02

If you know the trash compactor repair part you need, you can browse the list of all parts on the ZCG3300VWW-02, or you can search by name or part description. You can also find your part by where it is located on the ZCG3300VWW-02 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZCG3300VWW-02 [Viewing 4 of 4]


Single Roller

Sold individually.


Compactor Bags - 12 Pack


NUT 5/16-18


Trunnion Nut - Metal

Sold individually.




Drive Chain

Also known as Endless Chain. Sold individually.


Gear Box Kit






Bag Caddy

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Compactor Piston stays down even though the motor is running

  • Customer: Robert from San Deigo CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 11 of 15 people found this instruction helpful
If the drawer is stuck because the piston is in it, you will have to take the back off to lift the piston in order to remove the drawer.

With the drawer out, tip the compactor on its back to easily maneuver the otherwise heavy piston. Working from the front remove the trunnion nut cover (two hex screws) and then the bad trunnion. You may need to m... read more

Plastic trunnion nut was worn out

  • Customer: Joe from Avondale AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 7 of 9 people found this instruction helpful
The problem with this repair arises after you have removed the old trunion nut and you are trying to get the new one to seat into the narrow bracket that surrounds it and keeps it from turning. You can only screw the trunion nut on so far and then it runs into the edges of the bracket. I found that by aligning the new trunion nut at the proper angle and then... read more

Cheap original plastic trunnion nut broke.

  • Customer: Kenneth from Felton CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 2 of 2 people found this instruction helpful
Removed broken plastic tunion nut and replaced with new aluminum die cast trunnion nut. read more