Models > ZCG23SGSCSS

ZCG23SGSCSS General Electric Refrigerator - Overview

Get Parts and Repair Help for ZCG23SGSCSS

If you know the refrigerator repair part you need, you can browse the list of all parts on the ZCG23SGSCSS, or you can search by name or part description. You can also find your part by where it is located on the ZCG23SGSCSS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ZCG23SGSCSS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$9.20

Temperature Sensor

Also known as Thermistor. This part is used to sense the temperature in the cabinet.

$9.65

Defrost Thermostat

This part acts as a safety device against over heating in case of mechanical failure.

$61.43

Ice and Water Filter

Sold individually. NOTE: As per the manufacture this is an updated water filter. If you have never installed the updated filter or your old filter was made by Culligan, you may ne...

$31.30

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$6.20

Dispenser Door Assembly or Flapper

This part mounts in the ice dispenser. **** The crank no longer comes with this part. You can use original crank. The crank is sold separately depending on model number of appli...

$15.89

Module Shelf Insert

This part is located in the front of the module shelf.

$33.84

Dispenser Auger

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

$2.23

Evaporator Fan Grommet - Red

$23.20

Water Tank Assembly

This tank stores water until the water actuator is activated and water is requested.

$2.14

Dispenser Light Bulb - 12V

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge too warm, evaporator icing up

  • Customer: Gerald from San Clemente CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 223 of 259 people found this instruction helpful
After replacing the defrost heater, main board and thermistor I still had the same problem. Called a repair guy and he (with the help of GE on the phone) diagnosed that the temperature sensor was bad. So I ordered from partselect and installed it and it fixed the problem. Been good for a couple months (knocking on wood). To install I had to cut the 2 wir... read more

flap to ice dispenser would not close

  • Customer: Bill from Cleveland Heights OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 201 of 221 people found this instruction helpful
The flap to the ice dispenser would not close, which allowed the ice dispenser to frost up, freezing the water dispenser.

This was a simple fix. The solenoid had stopped working, so it would not automatically close the door flap. I read some posts on this site that suggest that you had to remove the trim around the entire dispenser to get at the... read more

Replace water filter

  • Customer: Alfred from Novato CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 167 of 249 people found this instruction helpful
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple. read more