Models > ZCE23SGTCSS

ZCE23SGTCSS General Electric Refrigerator - Overview

Get Parts and Repair Help for ZCE23SGTCSS

If you know the refrigerator repair part you need, you can browse the list of all parts on the ZCE23SGTCSS, or you can search by name or part description. You can also find your part by where it is located on the ZCE23SGTCSS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ZCE23SGTCSS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$9.20

Temperature Sensor

Also known as Thermistor. This part is used to sense the temperature in the cabinet.

$6.20

Dispenser Door Assembly or Flapper

This part mounts in the ice dispenser. **** The crank no longer comes with this part. You can use original crank. The crank is sold separately depending on model number of appliance.

$61.43

Ice and Water Filter

Sold individually. NOTE: As per the manufacture this is an updated water filter. If you have never installed the updated filter or your old filter was made by Culligan, you may ne...

$31.30

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$2.23

Evaporator Fan Grommet - Red

$3.02

Recess Door Spring

$15.89

Module Shelf Insert

This part is located in the front of the module shelf.

$11.11

Dispenser Crusher Cover

$2.14

Dispenser Light Bulb - 12V

Sold individually.

$42.81

Evaporator Fan Motor

Note: Thermistor is NOT included. If you need the motor with the thermistor, see related parts. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge too warm, evaporator icing up

  • Customer: Gerald from San Clemente CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 226 of 262 people found this instruction helpful
After replacing the defrost heater, main board and thermistor I still had the same problem. Called a repair guy and he (with the help of GE on the phone) diagnosed that the temperature sensor was bad. So I ordered from partselect and installed it and it fixed the problem. Been good for a couple months (knocking on wood). To install I had to cut the 2 wir... read more

flap to ice dispenser would not close

  • Customer: Bill from Cleveland Heights OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 204 of 224 people found this instruction helpful
The flap to the ice dispenser would not close, which allowed the ice dispenser to frost up, freezing the water dispenser.

This was a simple fix. The solenoid had stopped working, so it would not automatically close the door flap. I read some posts on this site that suggest that you had to remove the trim around the entire dispenser to get at the... read more

Replace water filter

  • Customer: Alfred from Novato CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 167 of 249 people found this instruction helpful
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple. read more