Models > YWFE366LVQ0

YWFE366LVQ0 Whirlpool Range - Overview

Get Parts and Repair Help for YWFE366LVQ0

If you know the range repair part you need, you can browse the list of all parts on the YWFE366LVQ0, or you can search by name or part description. You can also find your part by where it is located on the YWFE366LVQ0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YWFE366LVQ0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$3.76

Rear Drawer Glide

$43.62

Oven Rack

Sold individually.

$66.29

Sensor

This temperature sensor detects the temperature within the oven cavity.

$18.07

2 Piece Broiler Pan

$3.82

SCREW

$4.65

Touch-Up Paint - White

$53.51

Broil Element

This broil element is found on the roof of the oven.

$36.98

Infinite Control Switch - 6"

This switch controls the stove top surface burner.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

temperature not accurate after 3 1/2 years of happy usage

  • Customer: Ruth from Oregon IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 50 of 102 people found this instruction helpful
Opened up the back of the stove. Unpluged the sensor. Replaced the sensor. Replace the back of the stove.

The sensor that has been replaced is not what is expected. After reading all of the instructions for adjusting the temperatures, the only temp that stays steady is when we first turn on the oven to 350 degrees. That stays steady but when I tur... read more

Replace shattered outer door glass

  • Customer: Philip from Vandalia MI
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 22 of 29 people found this instruction helpful
This is not the best design. You'll need to have an extra set of hands to hold the trim pieces in place. Remember the glass is positioned outside [on top of]the trim pieces. Be careful as the trim pieces are rather brittle and can be hard to locate in their proper position. Position glass in the holding tabs at the bottom, hold glass against the trim piece... read more

SURFACE ELEMENT OUT

  • Customer: Terry from Rockwall TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 16 of 18 people found this instruction helpful
Took 2 screws under front edge of smooth top. Unscrewed ground wire from back of smooth top unit. Unplugged 2 wire bundles, from back. Took bad element out , put in new one. Put back together. About 10 min's tops. Easy Peasy. read more