YWED9750WL0 Whirlpool Dryer - Instructions

Removed lint filter cover (3 screws). Removed old lint filter. Adjusted metal guide. Reinstalled lint filter cover (3 screws). Installed lint filter. Replacement filter is a like quality.

remove back of dryer and install new part

First I take off the top panel , then take out four screw of console panel and disconnected wire from machine electric panel . Now I take four screw of door panel , disconnected door switch and take door panel out . Next step is to take 2 screw at blow housing and take this part out . Now I have enough room to take off two wire of the old thermal fuse and thermistor without removing the drum . Pull out old thermal fuse and thermisor , install the new one, reconnect two wire for each of them and reinstall all of part I take out before .The dyer work good after that but in the next day the dyer won't start again .I some time hear the sound bip bip together with the light from console panel even though I don't press any buttom at all .I thought either machine control electric or user interface die . As a new customer of partselect , I would like to hear any idea from you . Thanks for reading .

Took 12 screws off the back. One screw for the fuse. $9.32 and 30 minutes and we're back in business!

Reversing dryer door swing was a simple operation using the easy-to-follow directions which is included in the Door Reversing Kit #PS2341187.

Removed existing parts and replaced with new high limit thermostat and thermal fuse kit,replaced flue and tested. Worked like a charm.

replsce

First removed and checked the ignighter. It was fine. Next I located the schematic drawing and discovered that the burner, ignighter, and flame detector were all operated by one simple 110 volt circuit. This circuit did not power up when the dryer was cycled on. I pulled the dryer from the wall, removed the back panel, the vent etc. I then located the operating thermostat and the thermal fuze. The thermal fuze was open. (GOOD NEWS AN EASY FIX!!!) Thanks Guys

Well the video showed us taking off the back. Which wouldn't come off. Welded. Then we could not find the fuse in back of the unit or bottom. The second time we tried we found it in the front. We had to take off the front, bottom cover then we found the fuse. But, it didn't fix the problem. The unit is still on Casual load only. When we push the buttons the other lights light up but goes back to Casual. The unit is clear of lint and still drys but only at the Casual setting.

Pushed the new catch in by hand. Working great.

unplugged unit, removed the back panel replace thermo fuse and replace back panel, plugged electric cord back in and we were back in business. real easy fixx

I followed the video on the website, removing the back of the dryer, then located and removed the thermal fuse, replaced it with the new one..... Presto, it worked... Replaced the back of the dryer and was good to go... Thank you Part Select

replaced thermo fuse. not the problem. not sure how to test for next step. timer, cycler tumbler all work just won't fire up.

Went to your web site and found 40% of the time the thermal fuse is the problem. By using your site found how to locate fuse & test it. It took me 10 min to take out the old part & tested it to find it bad. I ordered the part which cost $10 & got it in 3 days. It took me 10 min to install it and the dryer is fine. This save me a big repair bill.

4 screws very easy and you gave excellant directions on how to replace