YWED9600TU0 Whirlpool Dryer - Instructions

Took off the backplate of dryer, replaced fuse, done.

My way of replacing the pulley was much faster than the parts select video that showed how to replace the belt tension-er pulley. They took off the door, the entire front AND the drum to get to the pulley. I ACCESSED THE PULLEY BY REMOVING THE 4 INCH EXHAUST PIPE, (ONE SCREW) WHICH GAVE MORE THAN ENOUGH OPENING TO REPLACE THE NEARBY PULLEY! I suggest you remake that video

The repair was easy--thanks to your excellent videos--also, delivery was prompt and correct--your service is excellent--but, looks like I'll need another part--maybe door latch??? I'll troubleshoot and definitely contact PartSelect--Thank you--will recommend you!

We only had to tilt the dryer enough to be able to screw the leveling leg in place.The only hard part was holding the dryer steady to screw in the leveling foot.

I removed the back panel of the dryer and the thermal fuse was about three quarters down the dryer. The exploded parts schematic was very helpful. I simply removed two screws to replace the thermal fuse and reinstalled the back panel. The dryer works great now.

Using the video on the site I was able to open the back on the dryer, replaced the thermal fuse and close it up in less than 15 minutes. Works great and saved me a ton of money.

I simply unplugged the dryer and removed the backing. Once off I located the part which was in plain sight, unhooked the wires and attached them to the new part. Put backing back on plugged it in and turned it on and it worked.

Opened machine up, removed electric control panel, removed door assembly, removed lint collector assembly, removed and replaced 2 sensor bars then reassembled machine. Ended up not being the problem but, I now have new moisture sensing bars.

The tear down on the dryer was more difficult than the instructions and internet showed due to different models used. The kit was not identical to the original parts but close enough to work (I think). The biggest issue we had was getting the drum back in and placed on the wheels where it would turn easily. Overall the repair came together but it was a bit more involved and we anticipated going into the project. The actual noises were caused by the disintegration of the tensioner wheel which broke and was wobbling on the axel.

Removed lint filter cover (3 screws). Removed old lint filter. Adjusted metal guide. Reinstalled lint filter cover (3 screws). Installed lint filter. Replacement filter is a like quality.

remove back of dryer and install new part

First I take off the top panel , then take out four screw of console panel and disconnected wire from machine electric panel . Now I take four screw of door panel , disconnected door switch and take door panel out . Next step is to take 2 screw at blow housing and take this part out . Now I have enough room to take off two wire of the old thermal fuse and thermistor without removing the drum . Pull out old thermal fuse and thermisor , install the new one, reconnect two wire for each of them and reinstall all of part I take out before .The dyer work good after that but in the next day the dyer won't start again .I some time hear the sound bip bip together with the light from console panel even though I don't press any buttom at all .I thought either machine control electric or user interface die . As a new customer of partselect , I would like to hear any idea from you . Thanks for reading .

Took 12 screws off the back. One screw for the fuse. $9.32 and 30 minutes and we're back in business!

Reversing dryer door swing was a simple operation using the easy-to-follow directions which is included in the Door Reversing Kit #PS2341187.

Removed existing parts and replaced with new high limit thermostat and thermal fuse kit,replaced flue and tested. Worked like a charm.