Models > YSF315PEMQ0

YSF315PEMQ0 Whirlpool Range - Overview

Get Parts and Repair Help for YSF315PEMQ0

If you know the range repair part you need, you can browse the list of all parts on the YSF315PEMQ0, or you can search by name or part description. You can also find your part by where it is located on the YSF315PEMQ0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YSF315PEMQ0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$39.49

Oven Igniter

This flat style gas oven igniter has ceramic housing and comes with a connector.

$28.25

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$10.89

Burner Knob

This white knob take a D-shaped shaft. Sold individually.

$5.05

Touch-Up Paint - White

18ml

$4.49

Push Nut

Used for door handle mounting stems.

$2.70

SCREW

Sold individually.

$53.83

Door Handle Kit - White

This handle kit includes the handle, 2 screws and 2 push nuts. The screws and push nuts are also sold separately.

$7.54

Spray Paint - 12 oz. - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 106 of 135 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

our oven would not heat up

  • Customer: sharnette from baltimore MD
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 44 of 48 people found this instruction helpful
My husband pulled out the stove turned the gas off then he pulled out the part and replaced igniter....it took only about 20 min to do this job it was very easy and prior to us doing ourselves i called a well known company that does home repairs, I also called a few smaller businesses and to replace this part was anywhere from $175- 250 if not more. we are v... read more

The igniter would turn orange but wouldn't fire up, so the oven wouldn't heat up.

  • Customer: Lisa from Livermore CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 16 of 18 people found this instruction helpful
I just unscrewed the old one out, which was 2 screws and screwed this one in. But the thing that was best of all was how fast the part came in. It literally came the next day. read more