Models > YSF315PEKQ1

YSF315PEKQ1 Whirlpool Range - Overview

Get Parts and Repair Help for YSF315PEKQ1

If you know the range repair part you need, you can browse the list of all parts on the YSF315PEKQ1, or you can search by name or part description. You can also find your part by where it is located on the YSF315PEKQ1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YSF315PEKQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$46.93

Oven Igniter

This flat style gas oven igniter has ceramic housing and comes with a connector.

$4.95

Touch-Up Paint - White

$11.79

Knob

This white knob take a D-shaped shaft. Sold individually.

$3.96

Rear Leveling Leg

Sold individually.

$2.70

SCREW

$7.54

Spray Paint - 12 oz. - White

$15.50

Leveling Foot

This adjustable front leveling foot is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 85 of 109 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

our oven would not heat up

  • Customer: sharnette from baltimore MD
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 32 of 35 people found this instruction helpful
My husband pulled out the stove turned the gas off then he pulled out the part and replaced igniter....it took only about 20 min to do this job it was very easy and prior to us doing ourselves i called a well known company that does home repairs, I also called a few smaller businesses and to replace this part was anywhere from $175- 250 if not more. we are v... read more

Oven would not heat.

  • Customer: Nedra from Alsip IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 13 of 15 people found this instruction helpful
Installing the part was really easy. I first turned the gas off, simply remove two screws tht hold the igniter in place. I then remove four screws from the back panel and disconnected the part. The feedback from other users on your site made me realize how easy it was. It took less than thirty minutes. read more