Models > YMT4070SKB1

YMT4070SKB1 Whirlpool Microwave - Overview

Get Parts and Repair Help for YMT4070SKB1

If you know the microwave repair part you need, you can browse the list of all parts on the YMT4070SKB1, or you can search by name or part description. You can also find your part by where it is located on the YMT4070SKB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$39.52

Turntable Motor

This motor rotates the glass turntable in the microwave.

$44.27

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$3.96

SPRING

$2.77

SCREW

$4.60

FOOT-BASE

$24.21

BRKT-LATCH

$20.05

LMP-BASLES

$74.79

Turntable Cooking Tray

$28.07

COVR-GUIDE

$16.04

High-Voltage Diode Wire

This part allows power to go only one way.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 29 of 35 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

Microwave went dead while in use.

  • Customer: Keith from Georgetown TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 19 of 22 people found this instruction helpful
1. removed vent across the top to gain excess to Screw holding control in place. 2. Removed control panel to access Fuse. 3. Remover fuse after pulling plug. 4.Tested fuse for continuity with volt ohm meter noting no continuity.5. Orderd new fuse. 6. receeived new fuse and installed infuse holder.7. plugged microwave plug back in receptical and tested unit n... read more

Close the door on the microwave, punch in the # nothing happened

  • Customer: Robert S. from Stafford TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 12 people found this instruction helpful
I removed the unit from the wall. Took the cover off. Set the unit on its side. It revealed the working parts. Removed the old micro switches. Put in the new oness. Presto, it worked. Very easy for me.
The parts was delivered almost before my notice they were shipped. read more