Models > YMT3110SHB0

YMT3110SHB0 Whirlpool Microwave - Overview

Get Parts and Repair Help for YMT3110SHB0

If you know the microwave repair part you need, you can browse the list of all parts on the YMT3110SHB0, or you can search by name or part description. You can also find your part by where it is located on the YMT3110SHB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$18.81

Turntable Roller Guide

This roller is located underneath the glass turntable. With the help of the motor, this roller helps to rotate the glass tray. This part takes the place of the coupling.

$44.27

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$2.70

Wave Guide Rivet

This rivet is used for the stirrer cover/wave guide. They are sold individually.

$28.46

Door Latch

This black door latch enables the switches to make sure that the door is closed before it operates.

$18.46

Guide Cover

$2.77

SCREW

$221.07

MAGNETRON

This part is used to generate microwave energy/heat.

$16.38

USE WPL 815174

$20.05

LMP-BASLES

$16.04

High-Voltage Diode Wire

This part allows power to go only one way.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 27 of 33 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

loud buzzing noise

  • Customer: Sandra from coto de caza CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 26 of 46 people found this instruction helpful
The repair went well...I am so glad that I read this info before buying a new microwave....it saved me lots of money. I did have a repair man come and look at it and he told me to buy a new one but it cost alot of money when it wasn't necessary. I did the repair and I was very proud of myself.
Three men watched a woman fix this and it was no problem...... read more

Broken tray ring for rotation of dish.

  • Customer: Michael from Sewanee TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 13 of 14 people found this instruction helpful
Used needle nose to pull off piece of old ring. Layed in new one. read more