YMEDZ600TW2 Maytag Dryer - Instructions

Took out the old one and put in the new one.

noticed that male half was in good working order, so I just snapped in the new female half; without any tools. easy repair!

Replaced with parts orded worked fine for2 hours and quit heating again

Found this part on your site very EZ bought it you shipped to my door got it when you said it would be here open it installed it propblem over glad i found you guys will use again Very good website Keep up the good work THANK YOU

We did repair by first watching a you tube video, then jumping in an dgoing step by step through the video. While not exactly the same dryer, the steps were in sequence. We thoroughly sleaned out the dryer with the tub out before reassembly. Th eonly slightly tricky part was putting front piece back, but once we mad esure ot align the sides for squareness the dryer went back together smoothly, execpt for one dropped screw. that was fished out through the bottom panel. The dryer runs quietly and we can watch TV with the door open to the laundry room again. I should have done this a long time ago. It started out by sqeaking at startup, then grew worse over time. I recomend anyone with a friend should be able to do this. Now with Cell phone pictures it is even easier to remember where the screw go.

Followed the directions from your vidio,it was a snap.You Guys are the greatest!!!

My husband changed the part but part select was very helpful. With their free repair help site it made repairing a breeze! We will use parts select again and again. I did order all the parts we might have needed and only needed one. Now I will return the others.

removed old one installed new one.

Took the back dryer cover off and removed the lint cover all from the back of the dryer then replaces the Thermistor (held with 2 screws).

I replace the terminal block, wires , and dryer plug I unscrewed the back of the dryer and basically replace was burnt out. I was about to pay 200.00 to have it done but I looked on youtube and seen how easy it was so I just chose the site to order what I needed to be replace and it arrived quickly and more affordable to do it myself. Thanks I hope the was useful.

No repair. Just replaced the screens in the dryer and they slide in and out to clean. The felt gets worn fast.

removed old one, threw it away, and inserted new one.

Using information found on this site, I was able to quickly locate the two bolts on the lower front panel of the dryer to get at the heating element. Once I removed the panel, I was able to use a multi-meter to determine that the heating element was the issue as the resistance reading was infinite opposed to the expected 10 ohms. When the replacement part arrived, I then re-accessed the heating element to remove it. I removed two bolts from the front deflector to gain access to the heating element (after opening the lower panel) and also removed a third bolt that held the heating element in. Once those were removed, I was able to remove the old heating element which was indeed bad as the wire was broken. I did find that it took a little effort to remove the old heating element. It was quite firmly placed in its location however once I put enough effort into it, it came out quite nicely and the replacement element went in quickly.

I watched a fix it video and than just followed what it said to do. My husband was very impressed and it saved us a lot of money. I had my dryer running in no time. Parts came very quickly after I ordered them. Thank you

Simply slid new idler wheel on then popped thr tri ring on. The belt replacment was the hardest thing which was also easy. I think pulling the dryer away from the wall was the most difficult thing.