Quick Question!

Have you ever purchased from PartSelect.com before?

Models > YMED6400TB0 Whirlpool

YMED6400TB0 Maytag Dryer - Overview

Get Parts and Repair Help for YMED6400TB0

If you know the dryer repair part you need, you can browse the list of all parts on the YMED6400TB0, or you can search by name or part description. You can also find your part by where it is located on the YMED6400TB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for YMED6400TB0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$32.08

Maintenance Kit

NOTE: This kit is for 29" wide dryers built 1965 or later. Please verify model # before ordering as may not work for all models. This kit comes with one multi-rib belt, two drum ...

$6.42

Heating Element Connection Wire Kit

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

$5.15

Leveling Foot

Sold individually.

$22.87

Door Seal with Adhesive

This part creates a seal around the door. High temperature adhesive is included.

$7.22

Touch-Up Paint - White

18ml

$23.73

Door Strike

This strike attaches to the front panel. Sold individually.

$36.93

SEAL

$34.56

Terminal and Wire Kit

$11.07

Spray Paint - 12 oz. - White

$18.14

Terminal Block Screw Kit

This kit includes 3 screws and 3 nuts.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer was working, but no heat.

  • Customer: ANTHONY from CHESHIRE, CT
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 1711 of 1945 people found this instruction helpful
First I unplugged the dryer, then removed the back panel, this exposed most all of the wiring and I could see the heater coils.
Not knowing what the problem was I started looking at the coils and could not see any broken parts.
So then checked the thermal fuse for continuity I removed the two wires from it with a small pair of needle nose pliers, ... read more

No heat but would run otherwise

  • Customer: Dana from Grassvally, CA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 575 of 596 people found this instruction helpful
Cleaning the lint out of the whole machine took quite a bit of time--it was everywhere. Underneath the lint trap was a collection that ultimately ruined the thermal fuse where it restricted the air flow considerably.

Ascertaining the problem was the most time consuming part.

The actual repair was quite simple and didn't take but 15-20 m... read more

Dryer overheated, blew out thermal fuse

  • Customer: Steven from East Norriton, PA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Socket set
  • 219 of 250 people found this instruction helpful
I started to repair this and got busy and ended up calling a repair service -- that was the first time. They repaired it for over $200 and said the cause was bad venting. I fixed the vent before using the fixed dryer but it blew again. So I ordered these parts and replaced them myself for a lot of savings. However, the dryer still overheated. Through lo... read more