YKHMS155LBL2 KitchenAid Microwave - Instructions

After researching online, I found that I needed the turntable drive coupling, part#PS993087. when I went to your site it showed the same part but the part number had changed but said it would fit my microwave. Well, I was really surprised and happy when the part I received 3 days after I placed the order, with normal shipping,fit perfectly and now my turn table in my microwave works. I have marked this site a a favorite and will use it I'm sure soon. Being a single women and having to figure out how to fix the things on a small buget, I'm learning a lot and have a lot of respect for men that know how to do all the repair stuff. Thanks so much, I have been able to mark this off my list of things to fix. Have a nice day. Cj- age, 58

This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.

Unscrewed the lens cover anbd inserted the new bulb. Put the cover back on and there was light!

Some difficulty getting screw loosened, once that was done replaced burned out bulb.

had to go on the internet to find out how to take front door apart..

Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.

just replaced the filters

Taking the door apart was easy once you figured out how it came apart. Youtube videos were not helpful as every brand of microwave is different; what works for one does not work for another. My Kitchenaide has little interior hooks on the inside of the door, 8 on top, 8 on bottom, 4 on the hinge side. You have to pry the door-skin up to get teh hook disengaged, then get a putty knife or similar to keep the hooks from re-engaging. Once you have about 6 or 7 undone, the door starts to come apart. Eventually the exterior of the door comes off; the interior of the door remains hinged. After that, you'll figure it out...

Removed microwave case and bad part was right there in plain sight attached to the magatron. Two screws and two wires and part replacement was done. Plugged in microwave and works perfect. Couldn't have been any easier. Thanks for the easy troubleshooting and parts suggestions on your site.

Others had suggested using a putty knife to "gently" remove the outer door panel. I found my narrow blade putty knife was not sturdy enough. After several attempts I finally switched to a wide blade putty knife and blade screwdriver. This did the trick. Outer door panel came away and after that it was relatively easy repair. I was really impressed by the wwll protected packaging used for shipping the new panel to me.

Removed door, removed panel, replaced panel, reinstalled door.

Ordered the part on PartSelect on Sunday afternoon. The part arrived on Tuesday evening. I followed the instructions on the reviews on the PartSelect site. 1. I took out the three (3) screws on the right side of the damaged panel. 2. I placed the screws in a bowl so not to lose them. 3. I pried the damaged front panel off with butter knife (it was a little harder to get off than expected). 4. I cleaned the glass. 5. I replaced the glass in the mounts on the new front panel. 6. I snapped the front panel into place and reinserted the screws. Boom. Done. I threw away the damaged front panel. I don't think it was recyclable.

replaced burnt parts

Super easy! Just unscrewed remainder of the vent grille, saving the old screws as instructed on other reviews I read, and replaced vent grille with perfectly fitting new one...whole process took 15 min (while 9 months pregnant with a toddler hanging on my leg!) And partselect sent the piece with regular shipping in 2 days!

Simply placed new dish on the rotating hub.