Models > YKGST307HW4

YKGST307HW4 KitchenAid Range - Overview

Get Parts and Repair Help for YKGST307HW4

If you know the range repair part you need, you can browse the list of all parts on the YKGST307HW4, or you can search by name or part description. You can also find your part by where it is located on the YKGST307HW4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKGST307HW4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$41.39

Inner Door Glass

$28.25

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$18.07

2 Piece Broiler Pan

$4.65

Touch-Up Paint - White

$4.46

Screw

This screw is sold individually.

$4.46

Light Gasket

$5.64

Bumper Pad Set of 4

***NOTE: This part has been substituted by the manufacturer and may not appear the same as the original but should function the same. These pads go on the bottom of your gas cook...

$57.82

Oven Igniter

This part is used to light the oven for the bake or broil. Be very careful to not touch the black element part of this igniter as it is very fragile.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 91 of 116 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Inside door glass broke

  • Customer: MANNY from LIVERMORE CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 60 of 68 people found this instruction helpful
I removed the oven door by lifting it off with the hinges. Disassembled the door parts one at time making sure I remember where I removed the screws until I am able to get to the broken glass. The most difficult part is making sure that the insulation strip & the gasket stayed in place after I replaced the broken glass & doing the reverse process of installi... read more

Oven wouldn't light

  • Customer: james from downers grove IL
  • Difficulty: Very Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required:
  • 35 of 52 people found this instruction helpful
My analysis was flawed. The $100 gas valve was acting erraticaly, so I replaced it. On a hunch, I took the top front off the stove and immediately saw a row of mini relays mounted on the $300 control board. The one labeled "bake" was black!
It is just too small for years of gas on / gas off high current. (The gas valve is indestructable. I took the ol... read more