Models > YKERS507HB1

YKERS507HB1 KitchenAid Range - Overview

Get Parts and Repair Help for YKERS507HB1

If you know the range repair part you need, you can browse the list of all parts on the YKERS507HB1, or you can search by name or part description. You can also find your part by where it is located on the YKERS507HB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERS507HB1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$41.39

Inner Door Glass

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$18.07

2 Piece Broiler Pan

$4.95

Touch-Up Paint - White

$4.46

Screw

This screw is sold individually.

$8.10

Drip Bowl - 6" - Black

Sold individually.

$9.11

8" Drip Bowl - Black

This black porcelain drip bowl with a hole in the bottom is intended for use with some electric ranges and cooktops.

$14.26

Surface Burner Knob

Sold individually.

$4.46

Light Gasket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Hidden bake element burned out.

  • Customer: Robert from Powell OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 75 of 87 people found this instruction helpful
This heating element is accessed from the right side of the range. The parts drawings are misleading, making you think that it can be accessed from below -- not so!

Remove the right side panel from the range by removing screws on back edge, and bottom center on the inside. Slide the panel forward to release from tabs on the front edge, then pull o... read more

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 81 of 105 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Oven not heating

  • Customer: Neil from Flemington NJ
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 61 of 73 people found this instruction helpful
Before you begin,some notes:

1. The wiring diagram on the rear of the oven incorrectly shows a bi-metal element in the L2 side of the oven heating element circuit. There is no bi-metal element in the circuit.
2. There is a fast blow 20 Amp fuse with radial leads in the L2 side of the oven heating element circuit which is NOT shown on the oven... read more