Models > YKERS205TS0

YKERS205TS0 KitchenAid Range - Overview

Get Parts and Repair Help for YKERS205TS0

If you know the range repair part you need, you can browse the list of all parts on the YKERS205TS0, or you can search by name or part description. You can also find your part by where it is located on the YKERS205TS0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERS205TS0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$30.74

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$3.76

Levelling Leg

This leg is sold individually.

$2.70

Screw

This screw is sold individually.

$59.44

Bake Element - 3600W

This bake element is found on the bottom of the oven.

$22.43

Knob - Stainless

Sold individually.

$5.54

Touch-Up Paint - White

$75.89

Surface Element with Limiter - 6" - 1200W

$83.79

Dual Element with Limiter - 2400W

With this element, you can adjust the size of the burner you want to use to match your pots/pans.

$28.95

Door Hinge - Left or Right Side

This door hinge can be used for the left or right side. As per the manufacture if the hinges have never been replaced,on the appliance,they suggest to replace the door hinge receptacle kit.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 61 of 66 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

Right rear burner went bad

  • Customer: Mark from Loxahatchee FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 57 of 62 people found this instruction helpful
Turned the breaker off, I removed 2 screws securing the range top to the range, opened the top and secured it in the up position, Removed the 2 screws securing the element ,one at a time I swapped the quick connectors from the old element to the new and repeated the process in reverse. I save over $100.00 in labor, plus most companies get you for a trip char... read more

Oven wouldn't get hot enough

  • Customer: Shawn from Atlantic Highlands NJ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 52 of 57 people found this instruction helpful
First and MOST IMPORTANTLY, I located the breaker switch for my oven and turned it off. I verified this by noticing that the electric clock on the oven display was no longer powered.

After removing all the oven racks, I removed the two screws at the bottom of the back end of the oven holding the metal "floor" in place.

Removing the... read more