Models > YKERS202BWH0

YKERS202BWH0 KitchenAid Range - Overview

Get Parts and Repair Help for YKERS202BWH0

If you know the range repair part you need, you can browse the list of all parts on the YKERS202BWH0, or you can search by name or part description. You can also find your part by where it is located on the YKERS202BWH0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERS202BWH0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$4.95

Touch-Up Paint - White

$66.29

Sensor

This temperature sensor detects the temperature within the oven cavity.

$43.07

Broiler Pan with Roasting Rack

$38.86

Infinite Control Switch - 6"

This switch controls the stove top surface burner.

$3.96

Rear Leveling Leg

Sold individually.

$2.70

Installation Screw

This screw is sold individually.

$9.83

ANCHOR-TIP

$17.05

ANCHOR-TIP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

temperature not accurate after 3 1/2 years of happy usage

  • Customer: Ruth from Oregon IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 47 of 98 people found this instruction helpful
Opened up the back of the stove. Unpluged the sensor. Replaced the sensor. Replace the back of the stove.

The sensor that has been replaced is not what is expected. After reading all of the instructions for adjusting the temperatures, the only temp that stays steady is when we first turn on the oven to 350 degrees. That stays steady but when I tur... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more

SURFACE ELEMENT OUT

  • Customer: Terry from Rockwall TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 15 of 17 people found this instruction helpful
Took 2 screws under front edge of smooth top. Unscrewed ground wire from back of smooth top unit. Unplugged 2 wire bundles, from back. Took bad element out , put in new one. Put back together. About 10 min's tops. Easy Peasy. read more