Models > YKERI204PW1

YKERI204PW1 KitchenAid Range - Overview

Get Parts and Repair Help for YKERI204PW1

If you know the range repair part you need, you can browse the list of all parts on the YKERI204PW1, or you can search by name or part description. You can also find your part by where it is located on the YKERI204PW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERI204PW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$33.21

Standard Y-Frame Surface Burner - 6" - 1500W

The manufacturer suggests replacing the receptacle at the same time.

$23.12

Receptacle Kit

This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.

$2.70

Screw

This screw is sold individually.

$42.22

Surface Burner Element Switch - 8"

This control switch controls the stove top 8" surface burner.

$50.88

Surface Element - 8" - 2100W

This element has looped terminal ends and 5-turns.

$2.70

Screw

$43.62

Oven Rack

Sold individually.

$66.29

Sensor

This temperature sensor detects the temperature within the oven cavity.

$4.11

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

the element did not turn compleatly off, the on light stayed on.

  • Customer: chaz from fairplay CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 21 of 24 people found this instruction helpful
removed the screws holding the back metal panel, this exposed the wires to the switch. tested the wires to find that they were live when the switch was in the off position. ordered a new switch. UNPLUGED THE STOVE. removed the knob on the front of the stove. this exposed 2 screws, removed screws and the switch came away from the stove. removed each wire fro... read more

Stove heat was inconsistent and

  • Customer: Thomas from Longwood FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 19 of 23 people found this instruction helpful
After turning off the circuit breaker, I removed the elements and pans, raised the top and cut the wires to the receptacle assembly. Stripped the wires, slid on the shrink tubing and applied the wire nuts. I used a hair dryer rather than a match to shrink the tubing. Reinstalled the drip pans and inserted the elements. The instructions were clear and th... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more