Quick Question!

Have you ever purchased from PartSelect.com before?

Models > YKERC506HW3

YKERC506HW3 KitchenAid Range - Overview

Get Parts and Repair Help for YKERC506HW3

If you know the range repair part you need, you can browse the list of all parts on the YKERC506HW3, or you can search by name or part description. You can also find your part by where it is located on the YKERC506HW3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERC506HW3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$21.46

2 Piece Broiler Pan

The top of this part is now black.

$7.22

Touch-Up Paint - White

18ml

$19.29

Single Drawer Roller

Used to slide the broiler drawer open and closed.

$11.07

Spray Paint - 12 oz. - White

$7.22

Touch-Up Paint - .6fl Ounce - Biscuit

$59.82

Surface Element Infinite Switch Kit

This switch controls the stove top surface burner.

$20.80

Spray Paint - Surperior Black

This is a 12oz can of black spray paint.

$90.13

Simmer Switch - White

$22.95

PRIMER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville, OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 123 of 159 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Inside door glass broke

  • Customer: MANNY from LIVERMORE, CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 91 of 100 people found this instruction helpful
I removed the oven door by lifting it off with the hinges. Disassembled the door parts one at time making sure I remember where I removed the screws until I am able to get to the broken glass. The most difficult part is making sure that the insulation strip & the gasket stayed in place after I replaced the broken glass & doing the reverse process of installi... read more

Radiant element, 2400 watt, under Ceran glass cok top needed replacement.

  • Customer: GEORGE from NEWNAN, GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 110 of 181 people found this instruction helpful
turned off power
removed ceran top from cabinet
removed element
installed new element
replaced top
powered up and was done read more