Models > YKERC506HT3

YKERC506HT3 KitchenAid Range - Overview

Get Parts and Repair Help for YKERC506HT3

If you know the range repair part you need, you can browse the list of all parts on the YKERC506HT3, or you can search by name or part description. You can also find your part by where it is located on the YKERC506HT3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for YKERC506HT3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$46.91

Inner Door Glass

$28.25

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$103.17

Dual Element with Limiter - 2500/1200W

With this element, you can adjust the size of the burner you want to use to match your pots/pans.

$5.48

Light Gasket

$4.54

Screw

This screw is sold individually.

$18.07

2 Piece Broiler Pan

The top of this part is now black.

$5.05

Touch-Up Paint - White

$101.16

Bake Element

This bake element has push-on wire terminals and is found at the bottom of your oven cavity.

$28.99

Light Lens

This part goes over top of the light bulb.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 100 of 129 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Inside door glass broke

  • Customer: MANNY from LIVERMORE CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 69 of 77 people found this instruction helpful
I removed the oven door by lifting it off with the hinges. Disassembled the door parts one at time making sure I remember where I removed the screws until I am able to get to the broken glass. The most difficult part is making sure that the insulation strip & the gasket stayed in place after I replaced the broken glass & doing the reverse process of installi... read more

Radiant element, 2400 watt, under Ceran glass cok top needed replacement.

  • Customer: GEORGE from NEWNAN GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 71 of 133 people found this instruction helpful
turned off power
removed ceran top from cabinet
removed element
installed new element
replaced top
powered up and was done read more