Models > YKDRU767VS00

YKDRU767VS00 KitchenAid Range - Overview

Get Parts and Repair Help for YKDRU767VS00

If you know the range repair part you need, you can browse the list of all parts on the YKDRU767VS00, or you can search by name or part description. You can also find your part by where it is located on the YKDRU767VS00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$14.55

Terminal Block

$63.84

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$8.07

Grate Feet - Pkg 4

$53.77

Temperature Probe

Also known as a meat probe.

$2.70

SCREW

$17.55

BULB-LIGHT

$17.23

ANCHOR-TIP

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

faulty meat probe

  • Customer: Kent from Seattle WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 16 of 26 people found this instruction helpful
Not a repair. Just needed to replace the meat probe sensor for the programmable oven. Quick and easy purchase and very fast delivery took care of the problem. I was back in business. read more

someone did not install cord properly! they left a strong strain on one of the 3 wires, with a loose nut connection that caused it to heat and melt the plastic that poped out toward the rear metal cover and short circuited.

  • Customer: Richard from Daytona Beach AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 11 of 14 people found this instruction helpful
I cut the ends of the cord and went with direct wire (no round eye clip) to the back side of the terminal block and tightened firmly. It took about 20 Minutes. read more

bought floor model with loose cord that melted block terminal

  • Customer: larry from alexandria IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 8 of 9 people found this instruction helpful
Safety first always shut breaker off at box.
I unplugged stove, disconnected wires keeping in mind the color placement. Unscrewed one ground screw and removed terminal block. Attached new block with ground screw, replaced wires in correct order, re-attached plug. Then reattached safety cover. Pretty simple for d.i.y. read more